Service 04 · Rewiring
Rewiring and remodel circuits
Cloth-insulated wire, ungrounded outlets and aluminum branch circuits are common in pre-1975 Sunnyvale homes. We rewire room by room with minimal opening, bring every outlet to grounded, AFCI-protected copper and coordinate with your remodel crew so walls are only opened once.
Who it is for
Whole-house rewires before a remodel, insurance-driven knob-and-tube removal, aluminum-wiring remediation and new circuits for kitchen, bath and ADU projects.
What is included
- Circuit-by-circuit survey with a written map of what stays and what goes
- New copper home runs, AFCI and GFCI as the code requires
- Grounded, tamper-resistant receptacles throughout
- Dedicated circuits for kitchen counters, bath, laundry, microwave, dishwasher
- Fishing through attics and crawlspaces instead of opening walls where possible
- Drywall patches marked for your painter, holes kept small
How the job runs.
Durations are typical for a Sunnyvale single-family home. Yours is confirmed on the site walk.
- Day 0
Site walk
We trace every circuit, test for grounding and aluminum, and photograph the attic and crawl.
- Week 1
Plan and permit
Scope agreed room by room. Permit pulled.
- Week 2–3
Rough
New home runs pulled, boxes set, old cable removed or abandoned per code.
- Week 4
Devices and inspection
Outlets, switches and plates in. Rough and final inspections passed.
Eight frames, one camera.
Eight stages from a typical job of this kind. Concept imagery.
01 · Existing
02 · Protected
03 · Opened
04 · Old cable out
05 · New home runs
06 · Boxes and devices
07 · Testing
08 · Finished
Questions we get on this job.
Do you have to open every wall?
No. Most runs go through the attic or crawlspace and drop down inside the wall. We open small holes at boxes and at fire blocks, and we mark every one for the painter.
Can we live in the house during a rewire?
Yes. We work one zone at a time and restore power to the rest of the house every evening.
What about aluminum wiring?
We either replace it or pigtail every termination with listed AlumiConn connectors. Insurance companies accept both; we recommend replacement where walls are open anyway.
Book a site walk for rewiring and remodel circuits.
No cost, no obligation. We measure, you decide.
Other services.
Service 01Panel upgrades100A to 200A, FPE and Zinsco replacement, meter-main combos.
Service 02EV charger circuitsLevel 2 chargers, 40–60A circuits, load-managed when the panel is full.
Service 03Lighting designRecessed, under-cabinet, pendants, dimming scenes. Layered, not just bright.
Service 05Outdoor and landscape lightingPath, step and tree lights on low-voltage, plus hard-wired exterior circuits.